Sheet Metal Connectors, Inc. manufactures rectangular fittings in most sizes and configurations. Fittings are manufactured on our state of the art fabrication equipment. All fittings are fabricated with stiffening beads on duct sizes 19” wide and larger which have more than 10 square feet of unbraced panel. Fittings shall be beaded unless duct will have an insulation covering or an acoustical liner. This requirement is applicable to 20 gauge or less in thickness and 3” W.G. or less. Most all fittings are fabricated with Pittsburgh seams. Fittings are available completely assembled with all accessories (reinforcement, vane & rail, etc…) installed. Fittings are also available knocked down to reduce shipping and handling costs.
All Rect. Duct and Fittings Products
- 90 Degree Increased Tap
- 90 Degree Increased Tap
- 90 Degree Square Throat Radius Heel Elbow
- Bullhead Tee
- Bullhead Tee Duct Fitting
- Concentric Duct Transition
- Duct Pants Fittings
- Offset Duct Pants
- Radius Duct Variable Angle
- Rectangular Duct Wrap
- Reducing Offset
- Reducing Offset – Left or Right
- Reducing Radius Elbow – Left or Right
- Square Throat Angle
- Straight 90 Degree Tap
- Transition – Top and Left Sides Flat
- Transition – Top and Right Sides Flat
- Y-Branch Pipe Fitting
Transition – Top and Right Sides Flat
TDC
S&D
Raw
Dimensions are O.D.
Category: Rect. Duct and Fittings
Related products
Rect. Duct and Fittings
Rect. Duct and Fittings
Rect. Duct and Fittings
Rect. Duct and Fittings
Rect. Duct and Fittings
Rect. Duct and Fittings
Rect. Duct and Fittings
Rect. Duct and Fittings
Rect. Duct and Fittings
Rect. Duct and Fittings
Rect. Doublewall
Rect. Duct and Fittings